PN7120, the best plug'n play full NFC solution - easy integration into any OSenvironment, with integrated firmware and NCI interface designed for contactlesscommunication at 13.56 MHz.

It is the ideal solution for rapidly integrating NFC technology in any application,especially those running O/S environment like Linux and Android, reducing Bill ofMaterial (BOM) size and cost, thanks to: full NFC forum compliancy with small form factor antenna embedded NFC firmware providing all NFC protocols as pre-integratedfeature direct connection to the main host or microcontroller, by I2C-busphysical and NCI protocol ultra-low power consumption in polling loop mode Highly efficient integrated power management unit (PMU) allowing directsupply from a battery

PN7120 embeds a new generation RF contactless front-end supporting various transmissionmodes according to NFCIP-1 and NFCIP-2, ISO/IEC14443, ISO/IEC 15693, ISO/IEC 18000-3,MIFARE and FeliCa specifications. It embeds an ARM Cortex-M0 microcontroller core loadedwith the integrated firmware supporting the NCI 1.0 host communication.

The contactless front-end design brings a major performance step-up with on one hand ahigher sensitivity and on the other hand the capability to work in active loadmodulation communication enabling the support of small antenna form factor.

For contactless card functionality, the PN7120 can act autonomously if previouslyconfigured by the host in such a manner.

PN7120 integrated firmware provides an easy integration and validation cycle as all theNFC real-time constraints, protocols and device discovery (polling loop) are being takencare internally. In few NCI commands, host SW can configure the PN7120 to notify forcard or peer detection and start communicating with them.

• Includes NXP ISO/IEC14443-A, Innovatron ISO/IEC14443-B and NXP MIFARE Crypto 1 intellectualproperty licensing rights
• ARM Cortex-M0 microcontroller core
• Highly integrated demodulator and decoder
• Buffered output drivers to connect an antenna with minimum number of externalcomponents
• Integrated RF level detector
• Integrated Polling Loop for automatic device discovery
• RF protocols supported
  • NFCIP-1, NFCIP-2 protocol
  • ISO/IEC 14443A, ISO/IEC 14443B PICC mode via host interface
  • ISO/IEC 14443A, ISO/IEC 14443B PCD designed according to NFC Forumdigital protocol T4T platform and ISO-DEP
  • FeliCa PCD mode
  • MIFARE PCD encryption mechanism (MIFARE 1K/4K)
  • NFC Forum tag 1 to 4 (MIFARE Ultralight, Jewel, Open FeliCa tag,DESFire)
  • ISO/IEC 15693/ICODE VCD mode
• Supported host interfaces
  • NCI protocol interface according to NFC Forum standardization
  • I2C-bus High-speed mode
• Integrated power management unit
  • Direct connection to a battery (2.3 V to 5.5 V voltage supply range)
  • Support different Hard Power-Down/Standby states activated byfirmware
  • Autonomous mode when host is shut down
• Automatic wake-up via RF field, internal timer and I2C-businterface
• Integrated non-volatile memory to store data and executable code forcustomization

• All devices requiring NFC functionality especially those running in an Android orLinux environment
• TVs, set-top boxes, Blu-ray decoders, audio devices
• Home automation, gateways, wireless routers
• Home appliances
• Wearables, remote controls, healthcare, fitness
• Printers, IP phones, gaming consoles, accessories

• PSMN4R1-60YL - N-channel 60 V, 4.1 mΩ logic level MOSFET in LFPAK56
• 2PD602AQL - 50 V，500 mA NPN通用晶体管
• PDZ36B - 稳压器二极管
• PDTC123T series - NPN配电阻晶体管；R1 = 2.2 kOhm，R2 = 开路
• 74LVC1G07 - 缓冲器，带开漏输出
• PCF8523TS - 实时时钟(RTC)和日历
• BAS40W - 通用肖特基二极管
• PSMN015-100B - N沟道TrenchMOS SiliconMAX标准电平FET
• 74AUP2G240 - 低功耗双路反相缓冲器/线路驱动器；3态
• PMEG2010AEJ - 20 V、1 A极低V_F MEGA肖特基势垒整流二极管，采用SOD323F封装